Stop/Tail/Turn Signal/ Sidemarker Lamp

To replace one of these lamps:

1. Open the liftgate. See Liftgate on page 2‑9.

2. Remove the two screw covers from the taillamp assembly.

3. Remove the two screws securing the taillamp assembly.

3. Remove the two screws securing the taillamp assembly.
4. Pull the taillamp assembly out of the vehicle body.
5. Disconnect the lamp wiring harness.

6. Turn the bulb socket counterclockwise and pull it out.

6. Turn the bulb socket counterclockwise and pull it out.
7. Pull the bulb straight out of the socket.
8. Install the new bulb.
9. Push the bulb socket in and turn it clockwise.
10. Reverse Steps 2 through 5 to reinstall the lamp assembly.

11. Verify that the taillamp assembly tab, located at the bottom of the taillamp

11. Verify that the taillamp assembly tab, located at the bottom of the taillamp assembly, is aligned to the facia bracket before securing with screws.

    See also:

    Vehicle Identification Number (VIN)
    Vehicle Identification Number (VIN) This legal identifier is in the front corner of the instrument panel, on the left side of the vehicle. It can be seen through the windshield from outside. The VI ...

    Object Detection System Messages
    PARK ASST BLOCKED SEE OWNERS MANUAL This message displays if there is something interfering with the park assist system. See Ultrasonic Parking Assist on page 9‑66 for more information. PARK A ...

    Adding Washer Fluid
    Open the cap with the washer symbol on it and add washer fluid until full. See Engine Compartment Overview on page 10‑6 for reservoir location. Notice ○ When using concentrated washe ...