Shifting Out of Neutral
To shift the transfer case out of N (Neutral) do the following:
1. Set the parking brake and apply the regular brake pedal.
2. Turn the ignition to ON/RUN with the engine off, and shift the transmission to N (Neutral).
3. Turn the transfer case dial to Two-Wheel Drive High.
After the transfer case has shifted out of N (Neutral), the N (Neutral) light will go out.
4. Release the parking brake prior to moving the vehicle.
Notice: Shifting the transmission into gear before the requested mode indicator light has stopped flashing could damage the transfer case. To help avoid damaging the vehicle, always wait for the mode indicator lights to stop flashing before shifting the transmission into gear.
5. Start the engine and shift the transmission to the desired position.
Excessively shifting the transfer case into or out of the different modes may cause the transfer case to enter the shift protection mode.
This will protect the transfer case from possible damage and will only allow the transfer case to respond to one shift per 10 seconds. The transfer case may stay in this mode for up to three minutes.
See also:
What to Add
Use only new DOT 3 brake fluid from a sealed container. See Recommended Fluids
and Lubricants on page 11‑12.
Always clean the brake fluid reservoir cap and the area around the cap before
re ...
Parking over Things That Burn
WARNING
Things that can burn could touch hot exhaust parts under the vehicle and ignite.
Do not park over papers, leaves, dry grass, or other things that can burn. ...
Brake System Messages
BRAKE FLUID LOW
This message is displayed when the brake fluid level is low; see Brake Fluid
on page 10‑24.
RELEASE PARKING BRAKE
This message is displayed as a reminder that the parking br ...