What to Add
Use only new DOT 3 brake fluid from a sealed container. See Recommended Fluids and Lubricants on page 11‑12.
Always clean the brake fluid reservoir cap and the area around the cap before removing it. This helps keep dirt from entering the reservoir.
WARNING
With the wrong kind of fluid in the brake hydraulic system, the brakes might not work well. This could cause a crash. Always use the proper brake fluid.
Notice
○ Using the wrong fluid can badly damage brake hydraulic system parts. For example, just a few drops of mineral-based oil, such as engine oil, in the brake hydraulic system can damage brake hydraulic system parts so badly that they will have to be replaced. Do not let someone put in the wrong kind of fluid.
○ If brake fluid is spilled on the vehicle's painted surfaces, the paint finish can be damaged. Be careful not to spill brake fluid on the vehicle. If you do, wash it off immediately.
See also:
Gasoline Specifications (U.S. and Canada Only)
At a minimum, gasoline should meet ASTM specification D 4814 in the United States or CAN/CGSB-3.5 or 3.511 in Canada.
Some gasolines contain an octane-enhancing additive called methylcyclopentadienyl ...
DIC Operation and Displays
Use the DIC buttons located in the center of the instrument panel to access different
displays. The DIC displays trip, fuel, vehicle system information, and warning messages.
It also shows the shi ...
Three-Way Calling
Three-way calling must be supported on the cell phone and enabled by the wireless
service carrier.
1. While on a call, press .
2. Say “Three&-way call.”
3. Use the dial or call command to ...