Storing the Tire Sealant and Compressor Kit
The tire sealant and compressor kit is located in the storage compartment on the driver side, at the rear of the vehicle.
1. Press down on the latch tab and pull the cover off to access the storage compartment.
2. Press the two tabs on the quick release buckle to release the tire sealant and compressor kit strap.
3. Remove the sealant and compressor kit from its tray.
To store the tire sealant and compressor kit, reverse the steps.
See also:
Starting the Vehicle
1. Press and release on the Remote
Keyless Entry transmitter.
2. Press and hold for about two
seconds. The turn signal lamps will briefly flash to confirm the vehicle has been
started. The pa ...
StabiliTrak® OFF Light
This light comes on when the StabiliTrak system is turned off. If the Traction
Control System (TCS) is off, wheel spin is not limited. If the StabiliTrak system
is off, the system does not assis ...
Remote Keyless Entry (RKE) System
The RKE transmitter is used to remotely lock and unlock the doors from up to 60 m (195 ft) away from the vehicle.
Press
to unlock the driver door.
Press
again within five seconds to unlock a ...