Starting the Vehicle

1. Press and release Keyless Entry transmitter. on the Remote Keyless Entry transmitter.

2. Press and hold seconds. The turn signal lamps will briefly flash to confirm the vehicle has been for about two seconds. The turn signal lamps will briefly flash to confirm the vehicle has been started. The parking lamps will turn on and remain on as long as the engine is running. The vehicle's doors will be locked.

3. The key must be inserted and turned to ON/RUN before driving.

The engine will shut off after 10 minutes unless a time extension is done or the key is inserted and turned to ON/RUN.

    See also:

    Heated and Ventilated Seats
    Heated and Cooled Seat Buttons Shown, Heated Seat Buttons Similar If available, the buttons are on the center console. To operate, the engine must be running. : If available, press to heat the ...

    Lumbar Adjustment
    Manual Lumbar If equipped, increase or decrease manual lumbar support by turning the knob forward or rearward. See Lumbar Adjustment on page 3‑4 for more information. Power Lumbar To ...

    Using the Tire Sealant and Compressor Kit without Sealant to Inflate a Tire (Not Punctured)
    To use the air compressor to inflate a tire with air only and not sealant: If a tire goes flat, avoid further tire and wheel damage by driving slowly to a level place. Turn on the hazard warning fl ...