Compass Calibration
The compass can be manually calibrated. Only calibrate the compass in a magnetically clean and safe location, such as an open parking lot, where driving the vehicle in circles is not a danger.
It is suggested to calibrate away from tall buildings, utility wires, manhole covers, or other industrial structures, if possible.
If CAL should ever appear in the DIC display, the compass should be calibrated.
If the DIC display does not show a heading, for example, N for North, or the heading does not change after making turns, there may be a strong magnetic field interfering with the compass. Such interference may be caused by a magnetic CB or cell phone antenna mount, a magnetic emergency light, magnetic note pad holder, or any other magnetic item. Turn off the vehicle, move the magnetic item, then turn on the vehicle and calibrate the compass.
To calibrate the compass, use the following procedure:
See also:
Instrument Panel (Base/Uplevel Version)
Instrument Panel (Base/Uplevel Version)
A. Air Vents on page 8‑11.
B. Turn and Lane-Change Lever.
See Turn and Lane-Change Signals on page 6‑6.
Windshield Wiper/Washer on page 5 ...
Where Are the Airbags?
The driver frontal airbag is in the center of the steering wheel.
The front outboard passenger frontal airbag is in the passenger side instrument panel.
Driver Side Shown, Passenger Side Simil ...
Manual Transfer Case
The transfer case shift lever is on the floor to the right of the driver.
Use this lever to shift into and out of Four-Wheel Drive.
A Four-Wheel Drive indicator light comes on when you shift int ...