When the System Does Not Seem To Work Properly

The RVC system may not work properly or display a clear image if:

○ The RVC is turned off. See “Turning the Rear Vision Camera System On or Off” earlier in this section.

○ It is dark.

○ The sun or the beam of headlights is shining directly into the camera lens.

○ Ice, snow, mud, or anything else builds up on the camera lens. Clean the lens, rinse it with water, and wipe it with a soft cloth.

○ The back of the vehicle is in an accident, the position and mounting angle of the camera can change or the camera can be affected. Be sure to have the camera and its position and mounting angle checked at your dealer.

    See also:

    Shifting Into Four-Wheel Drive Low
    When Four-Wheel Drive Low is engaged, vehicle speed should be kept below 72 km/h (45 mph). Extended high-speed operation in Four-Wheel Drive Low may damage or shorten the life of the drivetrain. To ...

    Tire and Loading Information Label
    Label Example A vehicle specific Tire and Loading Information label is attached to the vehicle's center pillar (B-pillar). With the driver's door open, you will find the label attached ...

    StabiliTrak® OFF Light
    This light comes on briefly while starting the engine. If it does not, have the vehicle serviced by your dealer. If the system is working normally, the indicator light then goes off. Press and rel ...