Pick-Up Box Identification and Fender Marker Lamps
The pick-up box identification lamps are LEDs. For replacement of the LED lighting assembly contact your dealer.
To replace a pickup box fender marker lamp bulb:
1. Press the tab from the back to remove the lamp.
2. Turn the bulb socket counterclockwise to remove from the lamp assembly.
3. Gently pry the bulb from the socket.
4. Install the new bulb in socket.
5. Reinstall socket into lamp assembly.
6. Reinstall the lamp assembly.
See also:
Compass Calibration
The compass can be manually calibrated. Only calibrate the compass in a magnetically clean and safe location, such as an open parking lot, where driving the vehicle in circles is not a danger.
It is ...
Sun Visors
Sun Visors
Pull the sun visor down to block glare. Detach the sun visor from the center mount to pivot to the side window, or to extend along the rod, if available. ...
Low Fuel Warning Light
English Shown, Metric Similar
This light comes on for a few seconds when the ignition is turned on as a check
to indicate it is working. If it does not come on, have it fixed.
The low fuel warni ...





