License Plate Lamp

To replace one of these bulbs:

1. Open the liftgate partway. See Liftgate on page 2‑9.

Passenger Side Shown, Driver Side Similar

Passenger Side Shown, Driver Side Similar

2. Push the left end of the lamp assembly toward the right.

3. Pull the lamp assembly down to remove it from the liftgate.

A. Bulb Socket

A. Bulb Socket
B. Bulb
C. Lamp Assembly

4. Turn the bulb socket (A) counterclockwise to remove it from the lamp assembly (C).

5. Pull the bulb (B) straight out of the bulb socket.

6. Push the replacement bulb straight into the bulb socket and turn the bulb socket clockwise to install into lamp assembly.

7. Turn the lamp assembly into the liftgate engaging the clip side first.

8. Push on the lamp side opposite the clip until the lamp assembly snaps into place.

    See also:

    Tire Pressure Light
    For vehicles with the Tire Pressure Monitor System (TPMS), this light comes on briefly when the engine is started. It provides information about tire pressures and the TPMS. ...

    Airbag Readiness Light
    This light shows if there is an electrical problem. The system check includes the airbag sensor(s), passenger sensing system, the pretensioners, the airbag modules, the wiring, and the crash sensing a ...

    Lamps
    Properly working headlamps, taillamps, and brake lamps are important to see and be seen on the road. • Signs that the headlamps need attention include dimming, failure to light, cracking, or damage ...