Adding Washer Fluid
The vehicle has a low washer fluid message on the DIC that comes on when the washer fluid is low. The message is displayed for 15 seconds at the start of each ignition cycle. When the WASHER FLUID LOW ADD FLUID message displays, washer fluid will need to be added to the windshield washer fluid reservoir.
Open the cap with the washer symbol on it. Add washer fluid until the tank is full. See Engine Compartment Overview on page 10‑6 for reservoir location.
Notice
• When using concentrated washer fluid, follow the manufacturer's instructions for adding water.
• Do not mix water with ready-to-use washer fluid.
Water can cause the solution to freeze and damage the washer fluid tank and other parts of the washer system.
Also, water does not clean as well as washer fluid.
• Fill the washer fluid tank only three-quarters full when it is very cold. This allows for fluid expansion if freezing occurs, which could damage the tank if it is completely full.
• Do not use engine coolant (antifreeze) in the windshield washer. It can damage the windshield washer system and paint.
See also:
USB-Supported Devices
• USB flash drive
• Portable USB hard drive
• Fifth generation or later iPod
• iPod nano
• iPod touch
• iPod classic
Not all iPods and USB drives are compatible with the USB port.
M ...
How to Inspect the Engine Air Cleaner/Filter
To inspect the air cleaner/filter, remove the engine air cleaner/filter from the vehicle by following Steps 1 through 6. When the engine air cleaner/filter is removed, lightly shake it to release loos ...
Viscosity Grade
SAE 5W-30 is the best viscosity grade for the vehicle. Do not use other viscosity grade oils such as SAE 10W-30, 10W-40, or 20W-50.
If in an area of extreme cold, where the temperature falls below &# ...