Adjusting the Speakers (Balance/Fade) (All Except AM-FM Radio and Radio with CD)

GMC Sierra / GMC Sierra Owners Manuals / Infotainment System / Introduction / Operation / Adjusting the Speakers (Balance/Fade) (All Except AM-FM Radio and Radio with CD)

BAL/FADE (Balance/Fade): To adjust the balance or fade:

1. Press the 2. Highlight the desired speaker control tab by doing one of the following: knob until the speaker control tabs display.

2. Highlight the desired speaker control tab by doing one of the following:

• Press the • Press the softkey under the desired tab. knob.

• Press the softkey under the desired tab.

3. Adjust the setting by doing one of the following:

• Turn the • Press the SEEK, or SEEK. knob clockwise or counterclockwise.

• Press the • Press the FWD, or REV. SEEK, or • Press the FWD, or REV. SEEK.

• Press the To quickly adjust all speaker and tone controls to the middle position, press the knob for more than two seconds. FWD, or To quickly adjust all speaker and tone controls to the middle position, press the knob for more than two seconds. REV.

To quickly adjust all speaker and tone controls to the middle position, press the If the Rear Seat Audio (RSA) is turned on, the radio disables FADE and mutes the rear speakers. knob for more than two seconds.

If the Rear Seat Audio (RSA) is turned on, the radio disables FADE and mutes the rear speakers.

    See also:

    Automatic Dimming Rearview Mirror
    The vehicle may have an automatic dimming inside rearview mirror. Automatic dimming reduces the glare from the headlamps of the vehicle behind you. The dimming feature comes on and the indicator ligh ...

    Using the Radio
    (Power/Volume): Press to turn the system on and off. Turn clockwise or counterclockwise to increase or decrease the volume. (Information) (AM-FM Radio and AM-FM Radio with CD): Press to switch the ...

    Storing and Deleting Phone Numbers
    The system can store up to 30 phone numbers as name tags in the Hands-Free Directory that is shared between the Bluetooth and OnStar systems, if equipped. The following commands are used to delete an ...