Tire Pressure
If the vehicle has the Tire Pressure Monitor System (TPMS), the pressure for each tire can be viewed in the DIC. The tire pressure will be shown in either kilopascals (kPa) or pounds per square inch (psi). Press the vehicle information button until the DIC displays FRONT TIRES kPa (PSI) LEFT ## RIGHT ##. Press the vehicle information button again until the DIC displays REAR TIRES kPa (PSI) LEFT ## RIGHT ##.
If a low tire pressure condition is detected by the system while driving, a message advising you to add pressure in a specific tire will appear in the display. See Tire Pressure on page 10‑62 and Tire Messages on page 5‑49 for more information.
If the tire pressure display shows dashes instead of a value, there may be a problem with the vehicle.
If this consistently occurs, see your dealer for service.
See also:
Using the Tire Sealant and Compressor Kit to Temporarily Seal and Inflate a
Punctured Tire
Follow the directions closely for correct sealant usage.
When using the tire sealant and compressor kit during cold temperatures, warm the kit in a heated environment for five minutes.
This will h ...
Jump Starting
For more information about the vehicle battery, see Battery on page 10‑25.
If the vehicle's battery has run down, you may want to use another vehicle and some jumper cables to start your vehicl ...
Finding a Category (CAT) Station
CAT (Category): The CAT button is used to find XM stations when the radio is in the XM mode.
To find XM channels within a desired category:
1. Press BAND until the XM frequency displays.
2. Press C ...