Flash-to-Pass
This feature is used to signal to the vehicle ahead that you want to pass.
If the headlamps are off or in the low-beam position, pull the turn signal lever toward you to momentarily switch to high beams.
Release the lever to turn the high-beam headlamps off.
See also:
Checking Engine Oil
It is a good idea to check the engine oil level at each fuel fill.
In order to get an accurate reading, the vehicle must be on level ground.
The engine oil dipstick handle is a yellow loop. See Engi ...
TPMS Malfunction Light and Message
The TPMS will not function properly if one or more of the TPMS sensors are missing
or inoperable. When the system detects a malfunction, the low tire pressure warning
light flashes for about one m ...
Battery Replacement
To change the remote control batteries, do the following:
1. Slide the rear cover back on the remote control.
2. Replace the two batteries in the compartment. Make sure they are installed correctly ...