Rear Safety Belt Comfort Guides

This vehicle may have rear safety belt comfort guides. If not, they are available through your dealer.

The guides may provide added safety belt comfort for older children who have outgrown booster seats and for some adults. When installed and properly adjusted, the comfort guide positions the shoulder belt away from the neck and head.

Here is how to install a comfort guide to the safety belt:

Outboard Positions
Outboard Positions

1. For the outboard positions, remove the guide from its storage clip on the interior body.

For the third row center position, locate the comfort guide which is located in a storage pocket, at the top of the seat, under the headrest on the driver side of the vehicle.

To access the comfort guide, you will first need to move the headrest forward by pulling on the handle behind the seatback.

The comfort guide will now be accessible.

Third Row Center Position
Third Row Center Position

Pull the comfort guide out of its storage location and then return the headrest to its upright position.

2. Place the guide over the belt and insert the two edges of the belt into the slots of the guide.

2. Place the guide over the belt and insert the two edges of the belt into the slots of the guide.

3. Be sure that the belt is not twisted and it lies flat.

3. Be sure that the belt is not twisted and it lies flat.

The elastic cord must be under the belt and the guide on top.

WARNING
A safety belt that is not properly worn may not provide the protection needed in a crash.

The person wearing the belt could be seriously injured. The shoulder belt should go over the shoulder and across the chest. These parts of the body are best able to take belt restraining forces.

4. Buckle, position, and release the safety belt as described previously in this section.

4. Buckle, position, and release the safety belt as described previously in this section.

Make sure the shoulder portion of the belt is on the shoulder and not falling off of it. The belt should be close to, but not contacting, the neck.

To remove and store the comfort guide, squeeze the belt edges together so that the safety belt can be removed from the guide.

Slide the guide into its storage location or on its storage clip.

    See also:

    Sheet Metal Damage
    If the vehicle is damaged and requires sheet metal repair or replacement, make sure the body repair shop applies anti-corrosion material to parts repaired or replaced to restore corrosion protection. ...

    Turn and Lane-Change Signals
    An arrow on the instrument panel cluster flashes in the direction of the turn or lane change. Move the lever all the way up or down to signal a turn. Raise or lower the lever for less than one sec ...

    Hands-Free Calling
    1. Push . System responds: “OnStar ready.” 2. Say “Dial.” System responds: “Please say the name or number to call.” 3. Say the entire number without pausing, including a “1” and the ...