Stop/Tail/Turn Signal/ Sidemarker Lamp

To replace one of these lamps:

1. Open the liftgate. See Liftgate on page 2‑9.

2. Remove the two screw covers from the taillamp assembly.

3. Remove the two screws securing the taillamp assembly.

3. Remove the two screws securing the taillamp assembly.
4. Pull the taillamp assembly out of the vehicle body.
5. Disconnect the lamp wiring harness.

6. Turn the bulb socket counterclockwise and pull it out.

6. Turn the bulb socket counterclockwise and pull it out.
7. Pull the bulb straight out of the socket.
8. Install the new bulb.
9. Push the bulb socket in and turn it clockwise.
10. Reverse Steps 2 through 5 to reinstall the lamp assembly.

11. Verify that the taillamp assembly tab, located at the bottom of the taillamp

11. Verify that the taillamp assembly tab, located at the bottom of the taillamp assembly, is aligned to the facia bracket before securing with screws.

    See also:

    Steering Wheel Controls
    If equipped, some audio controls can be adjusted at the steering wheel. (Next) : Press to go to the next favorite radio station, track on a CD, or folder on an iPod® or USB device. (Previous/En ...

    Shifting In or Out of Four-Wheel Drive Low
    Notice: Shifting the transfer case into Four-Wheel-Drive Low while moving at speeds faster than 5 km/h (3 mph) may cause premature wear to the transfer case, and may cause the gears to grind. To avoid ...

    Exterior
    There's hybrid badging on the cab's rear window, ahead of the side mirrors and on the tailgate, but otherwise the hybrid version looks similar to the gas-powered version. ...