Headlamps, Front Turn Signal, Sidemarker, and Parking Lamps
A. Low-Beam Headlamp
B. High-Beam Headlamp
C. Sidemarker Lamp
D. Park/Turn Signal Lamp
To replace one of these bulbs:
1. Turn the tire to reach the access port cap located in the front of wheel well cover.
A. Screw
B. Access Port Cap
2. Remove the screw (A) and turn the access port cap (B) counterclockwise to remove.
3. If replacing a headlamp bulb, remove the dust cover cap from the back of the headlamp housing by turning the cap counterclockwise.
4. Turn the bulb socket counterclockwise to remove it from the lamp assembly.
5. Remove the bulb from the socket or disconnect the bulb assembly from the harness
connector.
6. Install the new bulb.
7. Reinstall the bulb socket to the lamp assembly, turning clockwise.
8. Replace the dust cover cap on headlamps.
9. Reinstall the wheel well cover access port cap and secure by installing the screw.
See also:
Erasing Universal Home Remote Buttons
The programmed buttons should be erased when the vehicle is sold or the lease ends.
To erase either Rolling Code or Fixed Code settings on the Universal Home Remote device:
1. Press and hold the two ...
Before Driving Off-Road
○ Have all necessary maintenance and service work completed.
○ Fuel the vehicle, fill fluid levels, and check inflation pressure in all tires,
including the spare, if equipped.
○ ...
Cruise Control Light
The cruise control light is white whenever the cruise control is set, and turns
green when the cruise control is active.
The light turns off when the cruise control is turned off. See Cruise Cont ...