Three-Way Calling

Three-way calling must be supported on the cell phone and enabled by the wireless service carrier.

1. While on a call, press 2. Say “Three&-way call.”.
2. Say “Three&-way call.”
3. Use the dial or call command to dial the number of the third party to be called.
4. Once the call is connected, press b / g to link all callers together.

    See also:

    Rear Vision Camera Error Messages
    Service Rear Vision Camera System: This message can display when the system is not receiving information it requires from other vehicle systems. If any other problem occurs or if a problem persists, ...

    Add-on Electrical Equipment
    The OnStar system is integrated into the electrical architecture of the vehicle. Do not add any electrical equipment. See Add-On Electrical Equipment on page 9‑64. Added electrical equipment ...

    Using Voice Commands During a Planned Route
    Cancel Route 1. Push X. System responds: “OnStar ready,” then a tone. Say “Cancel route.” System responds: “Would you like to cancel route directions to your destination?” 2. Say “Ye ...