License Plate Lamp

To replace one of these bulbs:

1. Reach under the rear bumper for the bulb socket.

2. Turn the bulb socket counterclockwise and pull the bulb socket out of the lamp assembly.

2. Turn the bulb socket counterclockwise and pull the bulb socket out of the lamp assembly.

3. Pull the old bulb straight out from the bulb socket.

4. Install the new bulb.

5. Reverse Steps 1 and 2 to reinstall the bulb socket.

    See also:

    When to Add Engine Oil
    If the oil is below the cross-hatched area at the tip of the dipstick, add 1 L (1 qt) of the recommended oil and then recheck the level. See “Selecting the Right Engine Oil” in this section for ...

    Fuels in Foreign Countries
    Never use leaded gasoline or any other fuel not recommended in the previous text on fuel. Costly repairs caused by use of improper fuel would not be covered by the vehicle warranty. To check the fuel ...

    Instrument Panel Fuse Block
    The instrument panel fuse block access door is located on the driver side edge of the instrument panel. Pull off the cover to access the fuse block. The vehicle may not be equipped with all of t ...