Setting Cruise Control

If the cruise button is on when not in use, it could get bumped and go into cruise when not desired. Keep the cruise control switch off when cruise is not being used.

The cruise control light on the instrument panel cluster will come on after the cruise control has been set to the desired speed.

1. Press 2. Get up to the desired speed..

2. Get up to the desired speed.

3. Press the SET− button located on the steering wheel and release it.

4. Take your foot off the accelerator.

    See also:

    Daytime Running Lamps (DRL)
    Daytime Running Lamps (DRL) system makes the low-beam headlamps come on at a reduced brightness in daylight when the following conditions are met: ○ The ignition is on. ○ The exterior ...

    Compass Calibration Procedure
    1. Before calibrating the compass, make sure the compass zone is set to the variance zone in which the vehicle is located. See “Compass Variance (Zone) Procedure” earlier in this section. Do not ...

    Removing the Flat Tire and Installing the Spare Tire
    1. Do a safety check before proceeding. See If a Tire Goes Flat on page 10‑65 for more information. 2. For vehicles with a wheel cover or center cap, pull the cover or center cap away from ...