CD/DVD Player Messages
Disc Format Error: This message displays if the disc is inserted with the disc label wrong side up, or if the disc is damaged.
Disc Region Error: This message displays if the disc is not from a correct region.
No Disc Inserted: This message displays if no disc is present when the
or DVD/CD AUX button is pressed on the radio.
Optical Error: This message displays if the disc was inserted upside down.
Disk Read Error: This message displays if a disc was inserted with an invalid or unknown format.
Player Error: This message displays if there are disc load or disc eject problems.
• It is very hot. When the temperature returns to normal, the disc should play.
• The road is very rough. When the road becomes smoother, the disc should play.
• The disc is dirty, scratched, wet, or upside down.
• The air is very humid. If so, wait about an hour and try again.
• There was a problem while burning the disc.
• The label is caught in the CD/ DVD player.
If the disc is not playing correctly, for any other reason, try a known good disc.
If any error occurs repeatedly or if an error cannot be corrected, contact your dealer. If the radio displays an error message, write it down and provide it to your dealer when reporting the problem.
See also:
Using Voice Commands During a Planned Route
Cancel Route
1. Push . System responds:
“OnStar ready,” then a tone. Say “Cancel route.” System responds: “Would you like to cancel route directions to your destination?” 2. Say “Yes. ...
Compass Variance (Zone) Procedure
1. Do not set the compass zone when the vehicle is moving. Only set it when the vehicle is in P (Park).
Press the vehicle information button until PRESS TO CHANGE COMPASS ZONE displays. Or, if the v ...
Shifting out of Park
To shift out of P (Park):
1. Apply the brake pedal.
2. Turn the ignition to ON/RUN.
3. Press the shift lever button.
4. Move the shift lever.
If you still are unable to shift out of P (Park):
1. ...





