Button Retainer

Floor mats with a button-type retainer.

Removing and Replacing the Floor Mat
Removing and Replacing the Floor Mat

1. Pull up on the rear of the mat to unlock and remove.

2. Reinstall the floor mat by lining up the floor mat openings over the carpet retainers and snapping into position.

3. Make sure the floor mat is properly secured and verify that it does not interfere with the pedals.

    See also:

    Grade Braking (6-Speed Automatic Transmission)
    The Grade Braking shift modes can be activated by pressing the button on the end of the shift control lever. While in Range Selection Mode, Grade Braking is deactivated allowing the driver to select ...

    Range Selection Mode
    Range Selection Mode The Range Selection Mode switch, if equipped, is located on the shift lever. To enable the Range Selection feature: 1. Move the column shift lever to the M(Manual) position ...

    Starting the Engine Using Remote Start
    To start the engine using the remote start feature: 1. Press and release on the RKE transmitter. 2. Press and hold for about two seconds. The turn signal lamps will briefly flash to confirm th ...