When the System Does Not Seem To Work Properly
The RVC system may not work properly or display a clear image if:
○ The RVC is turned off. See “Turning the Rear Vision Camera System On or Off” earlier in this section.
○ It is dark.
○ The sun or the beam of headlights is shining directly into the camera lens.
○ Ice, snow, mud, or anything else builds up on the camera lens. Clean the lens, rinse it with water, and wipe it with a soft cloth.
○ The back of the vehicle is in an accident, the position and mounting angle of the camera can change or the camera can be affected. Be sure to have the camera and its position and mounting angle checked at your dealer.
See also:
Under the Hood
195-horsepower, 4.3-liter V-6 with iron block and cylinder heads,
cam-in-block, two valves per cylinder and 260 pounds-feet of torque
302-hp, 4.8-liter V-8 with iron block and aluminum cylinder hea ...
Headlamps, Front Turn Signal, Sidemarker, and Parking Lamps
A. Low-Beam Headlamp
B. High-Beam Headlamp
C. Sidemarker Lamp
D. Park/Turn Signal Lamp
To replace one of these bulbs:
1. Turn the tire to reach the access port cap located in the front of wheel ...
Stop/Tail/Turn Signal/ Sidemarker Lamp
To replace one of these lamps:
1. Open the liftgate. See Liftgate on page 2‑9.
2. Remove the two screw covers from the taillamp assembly.
3. Remove the two screws securing the taillamp asse ...