Finding a Station

BAND: Press to switch between AM, FM, or XM™, if equipped.

SEEK: Press to seek the previous radio station. Press and hold for a few seconds until a beep sounds to scan for radio stations in descending order; press the  SEEK button again to stop scanning radio stations. The radio only seeks and scans stations with a strong signal that are in the selected band. (Tune): Turn to manually select radio stations.

For the AM-FM Radio, press and hold the  SEEK for four seconds until a double beep sounds to scan the preset stations. The station frequency flashes while the radio is in the scan mode. SEEK: Press to seek the previous radio station. Press and hold for a few seconds until a beep sounds to scan for radio stations in descending order; press the For the AM-FM Radio, press and hold the  SEEK for four seconds until a double beep sounds to scan the preset stations. The station frequency flashes while the radio is in the scan mode. SEEK button again to stop scanning radio stations. The radio only seeks and scans stations with a strong signal that are in the selected band.

For the AM-FM Radio, press and hold the SEEK: Press to seek the next radio station. Press and hold for a few seconds until a beep sounds to scan for radio stations in ascending order; press the  SEEK button again to stop scanning radio stations. The radio only seeks and scans stations with a strong signal that are in the selected band. SEEK for four seconds until a double beep sounds to scan the preset stations. The station frequency flashes while the radio is in the scan mode.

For the AM-FM Radio, press and hold the  SEEK for four seconds until a double beep sounds to scan the preset stations. The station frequency flashes while the radio is in the scan mode. SEEK: Press to seek the next radio station. Press and hold for a few seconds until a beep sounds to scan for radio stations in ascending order; press the For the AM-FM Radio, press and hold the  SEEK for four seconds until a double beep sounds to scan the preset stations. The station frequency flashes while the radio is in the scan mode. SEEK button again to stop scanning radio stations. The radio only seeks and scans stations with a strong signal that are in the selected band.

For the AM-FM Radio, press and hold the REV: Press to manually tune to a radio station in descending order. SEEK for four seconds until a double beep sounds to scan the preset stations. The station frequency flashes while the radio is in the scan mode.

FWD: Press to manually tune to a radio station in ascending order. REV: Press to manually tune to a radio station in descending order.

FAV (Favorites): Press to select different favorites pages for stored radio stations. FWD: Press to manually tune to a radio station in ascending order.

FAV (Favorites): Press to select different favorites pages for stored radio stations.

    See also:

    When the System Does Not Seem To Work Properly
    The RVC system might not work properly or display a clear image if: • The RVC is turned off. See “Turning the RVC System On or Off” earlier in this section. • It is dark. • The sun or the ...

    Leaving After Parking on a Hill
    1. Apply and hold the brake pedal. 2. Start the engine. 3. Shift into a gear. 4. Release the parking brake. 5. Let up on the brake pedal. 6. Drive slowly until the trailer is clear of the chocks. ...

    Rear Wiper Blade Replacement
    The rear wiper blade and wiper arm have a cover for protection. The cover must be removed before the wiper blade can be replaced. To remove the cover: 1. Slide a plastic tool under the cover and ...