Engine Oil Life System
The engine oil life system calculates engine oil life based on vehicle use and displays the CHANGE ENGINE OIL SOON message when it is time to change the engine oil and filter. The oil life system should be reset to 100% only following an oil change.
Resetting the Oil Life System
1. Turn the ignition to ON/RUN, with the engine off.
2. Press the DIC MENU button to display the Vehicle Information menu.
3. Press either the up or down arrows to view REMAINING OIL LIFE.
4. Press the SET/CLR button until 100% is displayed.
5. Turn the key to LOCK/OFF. Or:
1. Turn the ignition to ON/RUN with the engine off.
2. Fully press and release the accelerator pedal three times within five seconds.
See also:
Power Liftgate 3/4 Mode
To program the liftgate opening height:
1. Turn the liftgate switch to either the MAX , or the 3/4 mode position and
power open the liftgate.
2. Stop the liftgate movement at the desired height by ...
Going & Stopping
The biggest drawback I found with the Yukon was the powertrain. A
380-horsepower, 6.2-liter V-8 is standard in the Denali, but it was sluggish in
almost every passing situation I could simulate. T ...
StabiliTrak® Indicator Light
This light comes on briefly while starting the engine. If it does not, have the vehicle serviced by your dealer. If the system is working normally, the indicator light goes off.
If it stays on, or ...