Removing Tools
The tools needed to remove the spare tire are located in the storage compartment on the driver side, at the rear of the vehicle.
1. Open the jack storage compartment by pulling on the latch tab, located toward the rear of the vehicle, and pulling the cover off.
A. Tool Bag
B. Wing Bolt
C. Jack
2. Remove the wing bolt (B) by turning it counterclockwise.
3. Push the jack (C) up out of the holding bracket and remove the tool bag (A).
4. Turn the jack on its side, with the bottom facing toward you.
5. Pull the jack straight out, bottom first.
A. Jack
B. Wrench (Three-Piece Shown, One-Piece Similar)
The tools you will be using include the jack (A) and wrench (B).
See also:
Using the Tire Sealant and Compressor Kit without Sealant to Inflate a Tire (Not Punctured)
To use the air compressor to inflate a tire with air only and not sealant:
If a tire goes flat, avoid further tire and wheel damage by driving slowly to a level place. Turn on the hazard warning fl ...
Exiting the Feature Settings Menu
The feature settings menu will be exited when any of the following occurs:
• The vehicle is no longer in ON/RUN.
• The trip/fuel or vehicle information DIC buttons are pressed.
• The end of t ...
Brake System Messages
BRAKE FLUID LOW
This message is displayed when the brake fluid level is low; see Brake Fluid
on page 10‑24.
RELEASE PARKING BRAKE
This message is displayed as a reminder that the parking br ...