Hood
To open the hood, do the following:
1. Pull the hood release handle with this symbol on it. It is located under the instrument panel on the driver's side of the vehicle.
2. At the front of the vehicle, pull up on the center of the hood, and push the secondary hood release to the right.
3. After you have partially lifted the hood, gas struts will automatically take over to lift and hold the hood in the fully open position.
Before closing the hood, be sure all filler caps are on properly.
Pull the hood down to close.
Lower the hood until the lifting pressure of the strut is reduced.
Then allow the hood to fall and latch into place under its own weight.
Check to make sure the hood is closed. If the hood does not fully latch, gently push the hood down at the front and center of the hood until it is completely latched.
See also:
Wheels and Trim—Aluminum or Chrome
Use a soft, clean cloth with mild soap and water to clean the wheels. After rinsing
thoroughly with clean water, dry with a soft, clean towel. A wax may then be applied.
Keep the wheels clean using ...
Parental Control
The RSE system may have a Parental Control feature, depending on the radio. To enable Parental Control, press and hold the radio power button for more than two seconds to stop all system features such ...
Power Seats
To adjust a power seat, if equipped:
• Move the seat forward or rearward by sliding the control forward or rearward.
• If available, raise or lower the front or rear part of the seat cushion ...