Finding a Category (CAT) Station
CAT (Category): The CAT button is used to find XM stations when the radio is in the XM mode.
To find XM channels within a desired category:
1. Press BAND until the XM frequency displays.
2. Press CAT to display the category tabs.
3. Continue pressing CAT until the desired category name displays.
• Radios with CD and DVD can also navigate the category list by pressing
REV or
FWD.
4. Press either of the two buttons below the desired category tab to immediately tune to the first XM station associated with that category.
5. To go to the next or previous XM station within the selected category, do one of the following:
• Turn
.
• Press the buttons below the right or left arrows on the display.
• Press either SEEK arrow.
6. To exit the category search mode, press the FAV button or BAND button to display the favorites again.
Undesired XM categories can be removed through the setup menu.
To remove an undesired category, perform the following:
1. Press MENU to display the radio setup menu.
2. Press the softkey below the XM CAT tab.
3. Turn
to display the category to be removed.
4. Press the softkey under the Remove tab until the category name along with the word Removed displays.
5. Repeat the steps to remove more categories.
Removed categories can be restored by pressing the softkey under the Add tab when a removed category is displayed or by pressing the softkey under the Restore All tab.
Categories cannot be removed or added while the vehicle is moving faster than 8 km/h (5 mph).
See also:
Cargo Cover
For vehicles with a cargo cover, use it to cover items in the rear of the vehicle.
To remove the cover from the vehicle, pull both ends toward each other. To reinstall,
place each end of the cover ...
Flash-to-Pass
This feature lets you use the high-beam headlamps to signal a driver in front of you that you want to pass. It works even if the headlamps are in the automatic position.
To use it, pull the turn sign ...
Compass Calibration Procedure
1. Before calibrating the compass, make sure the compass zone is set to the variance zone in which the vehicle is located. See “Compass Variance (Zone) Procedure” earlier in this section.
Do not ...





