Storing Memory Positions

To save into memory:

1. Adjust the driver seat, seatback recliner, and both outside mirrors.

See Power Mirrors on page 2‑16 for more information.

Not all vehicles will have the ability to save and recall the mirror positions.

2. Press and hold “1” until two beeps sound.

3. Repeat for a second driver position using “2.”

To recall, press and release “1” or “2.” The vehicle must be in P (Park).

A single beep will sound. The seat and outside mirrors will move to the position previously stored for the identified driver.

    See also:

    To Use the Engine Coolant Heater
    1. Turn off the engine. 2. Open the hood and unwrap the electrical cord. The cord is secured to the Engine Compartment Fuse Block with a clip. Carefully remove the wire tie which bundles the electric ...

    Park Brake and P (Park) Mechanism Check
    WARNING When you are doing this check, the vehicle could begin to move. You or others could be injured and property could be damaged. Make sure there is room in front of the vehicle in case it be ...

    Three-Way Calling
    Three-way calling must be supported on the cell phone and enabled by the wireless service carrier. 1. While on a call, press . 2. Say “Three&-way call.” 3. Use the dial or call command to ...