Floor Mats
WARNING
If a floor mat is the wrong size or is not properly installed, it can interfere with the pedals. Interference with the pedals can cause unintended acceleration and/or increased stopping distance which can cause a crash and injury. Make sure the floor mat does not interfere with the pedals.
Use the following guidelines for proper floor mat usage.
○ The original equipment floor mats were designed for your vehicle. If the floor
mats need replacing, it is recommended that GM certified floor mats be purchased.
Non-GM floor mats may not fit properly and may interfere with the accelerator or
brake pedal. Always check that the floor mats do not interfere with the pedals.
○ Use the floor mat with the correct side up. Do not turn it over.
○ Do not place anything on top of the driver side floor mat.
○ Use only a single floor mat on the driver side.
○ Do not place one floor mat on top of another.
See also:
Taillamps (Chassis Cab Models)
A. Backup Lamp
B. Stoplamp/Taillamp/Turn Signal Lamp
To replace one of these bulbs:
1. Remove the four screws.
2. Lift the lens off the lamp assembly.
3. Turn the old bulb counterclockwise and ...
Shifting Into Two-Wheel Drive High
Turn the knob to the Two-Wheel Drive High position. This can be done at any speed, except when shifting from Four-Wheel Drive Low.
See “Shifting Out of Four-Wheel Drive Low” for more information. ...
Other Information
The Bluetooth® word mark and logos are owned by the Bluetooth® SIG, Inc. and any use of such marks by General Motors is under license.
Other trademarks and trade names are those of their respective ...