Add-on Electrical Equipment
The OnStar system is integrated into the electrical architecture of the vehicle. Do not add any electrical equipment. See Add-On Electrical Equipment on page 9‑112. Added electrical equipment may interfere with the operation of the OnStar system and cause it to not operate.
See also:
Shifting Into Four-Wheel Drive High or AUTO
(Automatic Four-Wheel Drive)
Turn the knob to the Four-Wheel Drive High or AUTO position. This can be done at any speed, except when shifting from Four-Wheel Drive Low. The indicator light will flash while shifting. It will remai ...
Range Selection Mode
Range Selection Mode
The Range Selection Mode switch, if equipped, is located on the shift lever.
To enable the Range Selection feature:
1. Move the column shift lever to the M(Manual) position ...
When the System Does Not Seem To Work Properly
The RVC system might not work properly or display a clear image if:
• The RVC is turned off. See “Turning the RVC System On or Off” earlier in this section.
• It is dark.
• The sun or the ...





