How the System Works
URPA comes on automatically when the shift lever is moved into R (Reverse). A single tone sounds to indicate the system is working.
URPA operates only at speeds less than 8 km/h (5 mph).
An obstacle is indicated by audible beeps. The interval between the beeps becomes shorter as the vehicle gets closer to the obstacle.
When the distance is less than 30 cm (12 in) the beeping is a continuous tone for five seconds.
To be detected, objects must be at least 25 cm (10 in) off the ground and below tailgate level. Objects must also be within 2.5 m (8 ft) from the rear bumper. This distance may be less during warmer or humid weather.
See also:
Roadside Assistance Program (Mexico)
As a new owner, your vehicle is automatically enrolled in the Roadside Assistance program.
The services are available at no cost under the terms and conditions of the program. The Roadside Assistance ...
Fuses
The wiring circuits in the vehicle are protected from short circuits by fuses.
This greatly reduces the chance of damage caused by electrical problems.
Look at the silver-colored band inside the fu ...
Door Ajar Messages
DRIVER DOOR OPEN
This message displays and a chime may sound if the driver door is not fully closed and the vehicle is shifted out of P (Park). Stop and turn off the vehicle, check the door for obstr ...





