Camper/Fifth-Wheel Trailer Wiring Package
The seven-wire camper harness is located under the front edge of the pickup box on the driver side of the vehicle, attached to the frame bracket. A connector must be added to the wiring harness which connects to the camper.
The harness contains the following camper/trailer circuits:
• Yellow: Left Stop/Turn Signal
• Dark Green: Right Stop/Turn Signal
• Brown: Taillamps
• White: Ground
• Light Green: Back-up Lamps
• Red: Battery Feed
• Dark Blue: Trailer Brake
If the vehicle is equipped with the “Heavy-Duty Trailering” option, please refer to “Heavy-Duty Trailer Wiring Package” earlier in this section.
When the camper-wiring harness is ordered without the heavy-duty trailering package, a seven-wire harness with a seven-pin connector is located at the rear of the vehicle and is tied to the vehicle's frame.
See also:
How to Detect a Tamper Condition
If is pressed and the horn sounds,
an attempted break-in has occurred while the system was armed.
If the alarm has been activated, the THEFT ATTEMPTED message will appear on the
DIC. See Key and ...
Emissions Inspection and Maintenance Programs
Some local governments may have programs to inspect the on-vehicle emission control equipment.
For the inspection, the emission system test equipment is connected to the vehicle’s Data Link Connect ...
Anti-theft Alarm System Messages
SERVICE THEFT DETERRENT SYSTEM
This message displays when there is a problem with the theft-deterrent system. The vehicle may or may not restart so you may want to take the vehicle to your dealer bef ...