Voice Pass-Thru
Voice pass-thru allows access to the voice recognition commands on the cell phone. See your cell phone manufacturer's user guide to see if the cell phone supports this feature.
To access contacts stored in the cell phone:
1. Press and hold 
for two seconds.
2. Say “Bluetooth.” This command can be skipped.
3. Say “Voice.” The system responds “OK, accessing <phone name>.” The cell phone's normal prompt messages will go through their cycle according to the phone's operating instructions.
See also:
Compass Calibration Procedure
1. Before calibrating the compass, make sure the compass zone is set to the variance zone in which the vehicle is located.
See “Compass Variance (Zone) Procedure” earlier in this section.
Do not ...
Checking Engine Oil
It is a good idea to check the engine oil level at each fuel fill.
In order to get an accurate reading, the vehicle must be on level ground.
The engine oil dipstick handle is a yellow loop. See Engi ...
Inserting a Disc
Insert a disc partway into either slot, label side up. The player pulls it in and the disc should begin playing.
(Loading a disc into the system, depending on media type and format, ranges from 5 to ...