Engine Oil Life System

The engine oil life system calculates engine oil life based on vehicle use and, on most vehicles, displays a DIC message when it is necessary to change the engine oil and filter.

The oil life system should be reset to 100% only following an oil change.

Resetting the Oil Life System

To reset the Engine Oil Life System on most vehicles:

1. Display OIL LIFE REMAINING on the DIC. If the vehicle does not have DIC buttons, the vehicle must be in P (Park) to access this display.

2. Press and hold the SET/RESET button on the DIC, or the trip odometer reset stem if the vehicle does not have DIC buttons, for more than five seconds. The oil life will change to 100%.

On all vehicles, the Engine Oil Life System can be reset as follows:

1. Turn the ignition to ON/RUN with the engine off.

2. Fully press the accelerator pedal slowly three times within five seconds.

3. Display OIL LIFE REMAINING on the DIC. If the display shows 100%, the system is reset.

See Engine Oil Life System on page 10‑10.

    See also:

    Transmission
    Electronic Range Select (ERS) Mode ERS mode allows you to choose the top-gear limit of the transmission and the vehicle's speed while driving downhill or towing a trailer. The vehicle has an electro ...

    Exterior Lighting
    The exterior lamp control is located on the turn signal/lane change lever. : Turn to operate the exterior lamps. : Turns the exterior lamps off. AUTO: Turns the exterior lamps on and off automat ...

    Removing the Spare Tire and Tools
    To access the spare tire and tools: 1. Open the liftgate. See Liftgate on page 2‑9. 2. Lift the load floor up. Coin/Pierce Jack with One-Piece Wrench A. Extension B. Wheel Wrench C. Jack ...