Starter Switch Check

WARNING
When you are doing this inspection, the vehicle could move suddenly. If the vehicle moves, you or others could be injured.

1. Before starting this check, be sure there is enough room around the vehicle.

2. Firmly apply both the parking brake and the regular brake.

See Parking Brake on page 9‑28.

Do not use the accelerator pedal, and be ready to turn off the engine immediately if it starts.

3. Try to start the engine in each gear. The vehicle should start only in P (Park) or N (Neutral).

If the vehicle starts in any other position, contact your dealer for service.

    See also:

    New Vehicle Break-In
    Notice: The vehicle does not need an elaborate break-in. But it will perform better in the long run if you follow these guidelines: • Keep the vehicle speed at 88 km/h (55 mph) or less for the firs ...

    Parking Brake
    To set the parking brake, hold the regular brake pedal down, then push the parking brake pedal down. If the ignition is on, the brake system warning light will come on. See Brake System Warning ...

    Reducing Speed While Using Cruise Control
    If the cruise control system is already activated: • Press and hold the SET– button on the steering wheel until the lower speed desired is reached, then release it. • To slow down in small amo ...