Electric Trailer Brake Control Wiring Provisions
These wiring provisions for an electric trailer brake controller are included with the vehicle as part of the trailer wiring package.
The instrument panel contains blunt cut wires behind the steering column for the electric trailer brake controller. The harness contains the following wires:
• Red/Black: Power Supply
• White: Brake Switch Signal
• Gray: Illumination
• Dark Blue: Trailer Brake Signal
• Black: Ground
The electric trailer brake controller should be installed by your dealer or a qualified service center.
See also:
Interior Care
To prevent dirt particle abrasions, regularly clean the vehicle's interior. Immediately
remove any soils. Note that newspapers or dark garments that can transfer color
to home furnishings can ...
Reading Lamps
The reading lamps are located on the overhead console. These lamps come on automatically
when any door is opened.
For manual operation, press the button next to each lamp to turn it on or off. ...
Compass Calibration Procedure
1. Before calibrating the compass, make sure the compass zone is set to the variance zone in which the vehicle is located.
See “Compass Variance (Zone) Procedure” earlier in this section.
Do not ...