Compass Calibration Procedure

1. Before calibrating the compass, make sure the compass zone is set to the variance zone in which the vehicle is located.

See “Compass Variance (Zone) Procedure” earlier in this section.

Do not operate any switches such as window, sunroof, climate controls, seats, etc.

during the calibration procedure.

2. Press the vehicle information button until PRESS 3. Press the set/reset button to start the compass calibration. TO CALIBRATE COMPASS displays.

3. Press the set/reset button to start the compass calibration.

4. The DIC will display CALIBRATING: DRIVE IN CIRCLES. Drive the vehicle in tight circles at less than 8 km/h (5 mph) to complete the calibration. The DIC will display CALIBRATION COMPLETE for a few seconds when the calibration is complete. The DIC display will then return to the previous menu.

    See also:

    Jump Starting
    For more information about the vehicle battery, see Battery on page 10‑31. If the vehicle is a hybrid, see the hybrid supplement for more information. If the vehicle's battery (or batteries) h ...

    2010 GMC Terrain Review by G. Chambers Williams III
    Consumers can't seem to get enough of the all-new GMC Terrain compact crossover and its Chevrolet sibling, the Equinox. These fuel-efficient family vehicles are selling so well that the plant in ...

    What to Use
    Refer to Recommended Fluids and Lubricants on page 11‑12 to determine what kind of lubricant to use. ...