Removing the Third Row Seats

To remove a third row seat:

1. Remove the cargo management system, if available and installed. See Cargo Management System on page 4‑4.

2. Remove anything on or under the seat.

Notice: Folding a rear seat with the safety belts still fastened may cause damage to the seat or the safety belts. Always unbuckle the safety belts and return them to their normal stowed position before folding a rear seat.

3. Fold the seatback down.

See “Folding the Seatback” earlier in this section.

4. Remove the rear bolts on the floor on each side of the seat.

5. Remove the seat by tilting it slightly upward, and then pulling it out of the rear of the vehicle in one motion.

6. Replace the bolts in the floor holes for storage.

    See also:

    If the Off Indicator Is Lit for an Adult-Size Occupant
    If a person of adult-size is sitting in the front outboard passenger seat, but the off indicator is lit, it could be because that person is not sitting properly in the seat. Use the following steps ...

    Park Brake and P (Park) Mechanism Check
    WARNING When you are doing this check, the vehicle could begin to move. You or others could be injured and property could be damaged. Make sure there is room in front of the vehicle in case it begi ...

    Sunroof (Extended Cab)
    Sunroof (Extended Cab) On vehicles with a sunroof, the sunroof only operates when the ignition is in the ACC/ACCESSORY or ON/RUN or the Retained Accessory Power (RAP) is active. See Retained Acces ...