Heated and Ventilated Front Seats

GMC Acadia / GMC Acadia Owners Manual / Seats and Restraints / Front Seats / Heated and Ventilated Front Seats

WARNING
If you cannot feel temperature change or pain to the skin, the seat heater may cause burns even at low temperatures.

To reduce the risk of burns, people with such a condition should use care when using the seat heater, especially for long periods of time. Do not place anything on the seat that insulates against heat, such as a blanket, cushion, cover, or similar item. This may cause the seat heater to overheat.

An overheated seat heater may cause a burn or may damage the seat.

Heated and Cooled Seat Buttons Shown, Heated Seat Buttons Similar
Heated and Cooled Seat Buttons Shown, Heated Seat Buttons Similar

If available, the buttons are on the center console. To operate, the engine must be running.

(Cooled Seat): If available, press to cool the entire seat. (Heated Seatback): If available, press to heat the seatback only.

(Heated Seat and Seatback): (Cooled Seat): If available, press to cool the entire seat.

Press to heat the seat and seatback. (Heated Seat and Seatback):

Press to heat the seat and seatback.

Press the button once for the highest setting. With each press of the button, the seat will change to the next lower setting, and then to the off setting. The lights indicate three for the highest setting and one for the lowest.

The passenger heated seat may take longer to heat up.

The heated and/or cooled seats are canceled after the ignition is turned off.

Remote Start Heated Seats

When it is cold outside, the heated seats may turn on automatically during a remote vehicle start.

The heated seats will be canceled when the ignition is turned on. Press the desired heated seat button to use the heated seats after the vehicle is started.

The heated seat button lights will not turn on during a remote start.

The temperature of an unoccupied seat may be reduced.

See Remote Vehicle Start on page 2‑5 for more information.

    See also:

    Using Voice Commands During a Planned Route
    Cancel Route 1. Push X. System responds: “OnStar ready,” then a tone. Say “Cancel route.” System responds: “Would you like to cancel route directions to your destination?” 2. Say “Ye ...

    Trip Odometer
    Press the trip/fuel button until TRIP displays. This display shows the current distance traveled in either kilometers (km) or miles since the last reset for the trip odometer. Pressing the trip odome ...

    Sheet Metal Damage
    If the vehicle is damaged and requires sheet metal repair or replacement, make sure the body repair shop applies anti-corrosion material to parts repaired or replaced to restore corrosion protecti ...