Starting the Vehicle

With this feature the engine can be started from outside of the vehicle.

1. Aim the RKE transmitter at the vehicle.

2. Press and release 3. Immediately after completing Step 2, press and hold.

3. Immediately after completing Step 2, press and hold until the parking lamps flash.

When the vehicle starts, the parking lamps will turn on and remain on as long as the engine is running.

The doors will be locked and the climate control system may come on.

The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once.

    See also:

    Shifting Into Park
    WARNING It can be dangerous to get out of the vehicle if the shift lever is not fully in P (Park) with the parking brake firmly set. The vehicle can roll. If you have left the engine running, the ...

    Configurations for Use of Child Restraints
    ...

    Taillamps, Turn Signal, Stoplamps, and Back-Up Lamps
    To replace one of these bulbs: 1. Open the tailgate. See Tailgate on page 2‑10 for more information. 2. Remove the two rear lamp assembly screws near the tailgate latch strikerpost and pull ...