Using Voice Commands During a Planned Route
Cancel Route
1. Push X. System responds: “OnStar ready,” then a tone. Say “Cancel route.”
System responds: “Would you like to cancel route directions to your destination?”
2. Say “Yes.” System responds: “OK, route canceled.”
3. Say “Goodbye.” Exits voice commands.
Route Preview
1. Push X. System responds: “OnStar ready,” then a tone.
2. Say “Route Preview.” System responds with the next three maneuvers.
3. Say “Goodbye.” Exits voice commands.
Repeat
1. Push X. System responds: “OnStar ready,” then a tone.
2. Say “Repeat.” System responds with the last direction given, then responds with
“OnStar ready,” then a tone.
3. Say “Goodbye.” Exits voice commands.
Get My Destination
1. Push X. System responds: “OnStar ready,” then a tone.
2. Say “Get my destination.” System responds with miles to the destination, then
responds with “OnStar ready,” then a tone.
3. Say “Goodbye.” Exits voice commands.
See also:
Special Application Services
• Severe Commercial Use Vehicles Only: Lubricate chassis components every 5 000 km/3,000 mi.
• Have underbody flushing service performed once a year. ...
Trailer Gain Adjustment Procedure
Trailer Gain should be set for a specific trailering condition and must be adjusted any time vehicle loading, trailer loading, or road surface conditions change.
Setting the Trailer Gain properly is ...
When the System Does Not Seem To Work Properly
The RVC system may not work properly or display a clear image if:
○ The RVC is turned off. See “Turning the Rear Vision Camera System On or Off”
earlier in this section.
○ It is da ...