Fuses
The wiring circuits in the vehicle are protected from short circuits by fuses. This greatly reduces the chance of damage caused by electrical problems.
Look at the silver-colored band inside the fuse. If the band is broken or melted, replace the fuse. Be sure to replace a bad fuse with a new one of the identical size and rating.
Replace a bad fuse with a new one of the identical size and rating.
If there is a problem on the road and a fuse needs to be replaced, the same amperage fuse can be borrowed. Choose some feature of the vehicle that is not needed to use and replace it as soon as possible.
There are two fuse blocks in the vehicle: one in the engine compartment and one in the instrument panel.
There is a fuse puller located in the engine compartment fuse block. See Engine Compartment Fuse Block on page 10‑38. It can be used to easily remove fuses from the fuse block.
See also:
After Off-Road Driving
Remove any brush or debris that has collected on the underbody or chassis, or
under the hood. These accumulations can be a fire hazard. After operation in mud
or sand, have the brake linings clean ...
Power Lumbar
Power Lumbar
To adjust the power lumbar support, if equipped:
• On vehicles with two-way lumbar, press and hold the top or bottom of the control to increase or decrease lumbar support.
• On v ...
Used Replacement Wheels
WARNING
Replacing a wheel with a used one is dangerous. How it has been used or how far
it has been driven may be unknown. It could fail suddenly and cause a crash. When
replacing wheels, use a n ...





