How to Reset the Engine Oil Life System
Reset the system whenever the engine oil is changed so that the system can calculate the next engine oil change. To reset the system:
1. Turn the ignition to ON/RUN, with the engine off.
2. Press the DIC MENU button to display the Vehicle Information menu.
3. Press either the up or down arrows to view REMAINING OIL LIFE.
4. Press the SET/CLR button until 100% is displayed.
5. Turn the key to LOCK/OFF.
Or:
1. Turn the ignition to ON/RUN with the engine off.
2. Fully press and release the accelerator pedal three times within five seconds.
The system is reset when the CHANGE ENGINE OIL SOON message goes off.
If the CHANGE ENGINE OIL SOON message comes back on when the vehicle is started, the engine oil life system has not been reset. Repeat the procedure.
See also:
Ultrasonic Parking Assist
If available, Ultrasonic Rear Parking Assist (URPA) system uses sensors on the
rear bumper to assist with parking and avoiding objects while in R (Reverse). It
operates at speeds less than 8 km/h ...
Using Voice Commands During a Planned Route
Cancel Route
1. Push X. System responds: “OnStar ready,” then a tone. Say “Cancel route.”
System responds: “Would you like to cancel route directions to your destination?”
2. Say “Ye ...
Turn Signal Indicator
The vehicle may also have a turn signal indicator on the mirror. An arrow on the mirror flashes in the direction of the turn or lane change. ...