Filling the Tank
WARNING
Fuel vapor burns violently and a fuel fire can cause bad injuries. To help avoid injuries to you and others, read and follow all the instructions on the fuel pump island. Turn off the engine when refueling. Do not smoke near fuel or when refueling the vehicle. Do not use cellular phones. Keep sparks, flames, and smoking materials away from fuel. Do not leave the fuel pump unattended when refueling the vehicle. This is against the law in some places. Do not re-enter the vehicle while pumping fuel. Keep children away from the fuel pump; never let children pump fuel.
The tethered fuel cap is behind the fuel door on the vehicle's passenger side. To open the fuel door, push the rearward center edge in and release and the door will open. Turn the fuel cap counterclockwise to remove. Do not release the cap too soon or it will spring back. Reinstall the cap by turning it clockwise until it clicks.
If the cap is not properly installed, the malfunction indicator lamp will come on. See Malfunction Indicator Lamp on page 5‑13 for more information.
WARNING
Fuel can spray out on you if you open the fuel cap too quickly. If you spill fuel and then something ignites it, you could be badly burned. This spray can happen if the tank is nearly full, and is more likely in hot weather. Open the fuel cap slowly and wait for any hiss noise to stop. Then unscrew the cap all the way.
Do not top off or overfill the tank. Wait a few seconds before removing the nozzle. Clean fuel from painted surfaces as soon as possible. See Exterior Care on page 10‑83.
WARNING
If a fire starts while you are refueling, do not remove the nozzle. Shut off the flow of fuel by shutting off the pump or by notifying the station attendant. Leave the area immediately.
Notice: If a new fuel cap is needed, be sure to get the right type of cap from your dealer. The wrong type of fuel cap might not fit properly, might cause the malfunction indicator lamp to light, and could damage the fuel tank and emissions system. See Malfunction Indicator Lamp on page 5‑13.
See also:
Flash-to-Pass
The flash&-to&-pass feature works with the low beams or Daytime Running Lamps
(DRL) on or off.
To flash the high beams, pull the turn signal/lane change lever all the way toward
you, then ...
When to Check and Change Automatic Transmission Fluid
It is usually not necessary to check the transmission fluid level.
The only reason for fluid loss is a transmission leak or overheated transmission. If a small leak is suspected, then use the followi ...
Playing from a USB
A USB mass storage device or Microsoft Transfer Protocal (MTP) device can be
connected to the USB port.
The USB port is in the center console.
The USB icon displays when the USB device is connecte ...