New Vehicle Break-In
Notice: The vehicle does not need an elaborate break-in. But it will perform better in the long run if you follow these guidelines:
○ Do not drive at any one constant speed, fast or slow, for the first 805 km (500 mi). Do not make full-throttle starts. Avoid downshifting to brake or slow the vehicle.
○ During the first 1 000 km (600 mi), avoid using more than moderate acceleration in lower gears and avoid vehicle speeds above 110 km/h (68 mph).
○ Between the first 1 000 km (600 mi) and 5 000 km (3,000 mi), heavy acceleration in lower gears can be used. Vehicle speeds above 110 km/h (68 mph) should be limited to five minutes per use.
○ Avoid making hard stops for the first 322 km (200 mi) or so. During this time the new brake linings are not yet broken in. Hard stops with new linings can mean premature wear and earlier replacement. Follow this breaking-in guideline every time you get new brake linings.
○ Do not tow a trailer during break-in. See Driving Characteristics and Towing Tips on page 9‑57 for the trailer towing capabilities of your vehicle and more information.
Following break-in, engine speed and load can be gradually increased.
See also:
Storing Memory Positions
To save into memory:
1. Adjust the driver seat, seatback recliner, and both outside mirrors.
See Power Mirrors on page 2‑16 for more information.
Not all vehicles will have the ability to sav ...
Turning the System On and Off
The system can be disabled through the Driver Information Center (DIC).
See “Park Assist” under Vehicle Personalization (With DIC Buttons) on page 5‑46 for more information.
URPA defaults ...
Setting the Clock
To set the time and date:
1. Turn the ignition key to ACC/ ACCESSORY or ON/RUN, then press
, to turn the radio on.
2. Press
to display HR, MIN, MM, DD, and YYYY (hour, minute, month, day, and yea ...