Clock
To set the time:
1. Press the CONFIG button to enter the menu options. Turn the TUNE/MENU knob to scroll through the available setup features. Press the TUNE/MENU knob or press the Time screen button to display other options within that feature.
2. Press + or − to decrease or increase the Hours and Minutes displayed on the clock.
12/24 HR Format: Press the 12 HR screen button for standard time; press the 24 HR screen button for military time.
Day + or Day −: Press the Day + or Day − display buttons to increase or decrease the day.
Display: Press Display to turn the display of the time on the screen on or off.
See also:
Using Voice Commands During a Planned Route
Cancel Route
1. Push X. System responds: “OnStar ready,” then a tone. Say “Cancel route.”
System responds: “Would you like to cancel route directions to your destination?”
2. Say “Ye ...
Conditions in Which Remote Start Will Not Work
The remote vehicle start feature will not operate if:
○ The key is in the ignition.
○ The hood or doors are not closed.
○ The hazard warning flashers are on.
○ There is an ...
Lamp Messages
TURN SIGNAL ON
This message displays and a chime sounds if a turn signal is left on for 1.2 km (0.75 mile). Move the turn signal/multifunction lever to the off position. ...