Windshield Wipers
If the wiper motor overheats due to heavy snow or ice, the windshield wipers will stop until the motor cools and will then restart.
Although the circuit is protected from electrical overload, overload due to heavy snow or ice may cause wiper linkage damage.
Always clear ice and heavy snow from the windshield before using the windshield wipers.
If the overload is caused by an electrical problem and not snow or ice, be sure to get it fixed.
See also:
Button Retainer
Floor mats with a button-type retainer.
Removing and Replacing the Floor Mat
1. Pull up on the rear of the mat to unlock and remove.
2. Reinstall the floor mat by lining up the floor mat openings ...
Lamp Messages
TURN SIGNAL ON
This message displays and a chime sounds if a turn signal is left on for 1.2 km (0.75 mile). Move the turn signal/multifunction lever to the off position. ...
Engine Cooling When Trailer Towing
The cooling system may temporarily overheat during severe operating conditions.
See Engine Overheating on page 10‑20. ...