Center High-Mounted Stoplamp (CHMSL) and Cargo Lamp
To replace one of these bulbs:
1. Remove the two screws and lift off the lamp assembly.
A. Cargo Lamp
B. Center High-Mounted Stoplamp (CHMSL) Bulb
2. On the reverse side of the lamp assembly, remove the bulb socket by turning it one quarter turn counterclockwise and pull it straight out.
3. Remove the bulb by pulling it straight out of the socket.
4. Install the bulb by pushing the bulb straight into the socket.
5. Install the bulb socket into the lamp asembly by turning it one quarter turn clockwise.
6. Reinstall the lamp assembly and tighten the screws.
See also:
Turn and Lane-Change Signals
An arrow on the instrument panel cluster flashes in the direction of the turn or lane change.
Move the lever all the way up or down to signal a turn.
Raise or lower the lever until the arrow start ...
Environmental Concerns
• Always use established trails, roads, and areas that have been set aside for public off-road recreational driving and obey all posted regulations.
• Do not damage shrubs, flowers, trees, or gra ...
When the System Does Not Seem To Work Properly
The rear vision camera system might not work properly or display a clear image if:
• The RVC is turned off.
See “Turning the Rear Camera System On or Off” earlier in this section.
• It is d ...