Taillamps (Chassis Cab Models)
A. Backup Lamp
B. Stoplamp/Taillamp/Turn Signal Lamp
To replace one of these bulbs:
1. Remove the four screws.
2. Lift the lens off the lamp assembly.
3. Turn the old bulb counterclockwise and pull the it straight out from the socket.
4. Install a new bulb into the socket, turn it clockwise, and press it in until it is tight.
5. Reinstall the lens and the four screws.
See also:
How to Reset the Engine Oil Life System
Reset the system whenever the engine oil is changed so that the system can calculate the next engine oil change. Always reset the engine oil life to 100% after every oil change. It will not reset itse ...
Exterior Lighting
The exterior lamps control is located on the instrument panel to the left of the steering wheel.
: Turns off the automatic headlamps and Daytime Running Lamps (DRL). Turn the headlamp control ...
Engine Power Messages
ENGINE POWER IS REDUCED
This message displays and a chime sounds when the cooling system temperature gets too hot and the engine further enters the engine coolant protection mode.
See Engine Overhea ...