Camper/Fifth-Wheel Trailer Wiring Package
The seven-wire camper harness is located under the front edge of the pickup box on the driver side of the vehicle, attached to the frame bracket. A connector must be added to the wiring harness which connects to the camper.
The harness contains the following camper/trailer circuits:
• Yellow: Left Stop/Turn Signal
• Dark Green: Right Stop/Turn Signal
• Brown: Taillamps
• White: Ground
• Light Green: Back-up Lamps
• Red: Battery Feed
• Dark Blue: Trailer Brake
If the vehicle is equipped with the “Heavy-Duty Trailering” option, please refer to “Heavy-Duty Trailer Wiring Package” earlier in this section.
When the camper-wiring harness is ordered without the heavy-duty trailering package, a seven-wire harness with a seven-pin connector is located at the rear of the vehicle and is tied to the vehicle's frame.
See also:
Listing All Paired and Connected Phones
The system can list all cell phones paired to it. If a paired cell phone is also connected to the vehicle, the system responds with “is connected” after that phone name.
1. Press and hold for tw ...
INTERIOR
While the Acadia Denali's upgraded exterior is apparent, the interior falls a
little flat. It looks good, but it's not an up-to-date look. The instrument
cluster was blah-looking and seemed outdat ...
What to Add
Use only new DOT 3 brake fluid from a sealed container. See Recommended Fluids and Lubricants on page 11‑12.
Always clean the brake fluid reservoir cap and the area around the cap before removi ...